BK09
Colour
Required accessories
It is necessary to order one of the required accessories to properly install and operate the product:
Technical Data
last update: 02/12/2025Description
Double light emission outdoor wall-mounted luminaire, designed to use warm white LED lamps, with Up/Down light blade optic. For wall-mounting using the special steel plate. The luminaire consists of an optical assembly, rear base and plate for fixing to the wall. The optical assembly and rear base are made of die-cast aluminium alloy coated with liquid acrylic paint (grey finish) or textured liquid (white finish) with a high level of resistance to weather and UV rays. The wall plate is made of Aisi 304 stainless steel. Double light blade optic with two-component (acrylic and polycarbonate) lenses, joined to the optical assembly with silicone. Single stainless steel M14x1 cable gland and rubber outlet cable L=500mm. Double electronic circuit with warm white LED. Equipped with electronic ballast Vin 100-240V ac 50/60Hz. All external screws used are made of A2 stainless steel. The luminaire technical characteristics conform to EN60598-1 standards and particular requirements.
Dimensions
General (mm)
51x51x161
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Weight (kg)
0.56
Material
Aluminium
Product certification
-
BIS -
CE -
ENEC-03 -
QCERT
Photometric data
Details
lm system
63.2
W system
7.6
lm source
790
W source
5.7
Luminous efficiency - lm/W (system value)
8.32
lm in emergency mode
-
Total light flux at or above an angle of 90° (Lm)
32
Light output ratio (LOR)
8
Optic and beam angle
L / L - Light blade effect
Adjustability
fixed
Light colour quality
CRI (minimum) 80 - Rf (Colour Fidelity Index) 86 - Rg (Gamut Index) 96
Colour temperature
3000 K
MacAdam Step
3
Lifetime LED 1
100,000h - L80 - B10 (Ta 25°C)
Lifetime LED 2
100,000h - L80 - B10 (Ta 40°C)
Charts and polar curves
Electrical data
Operating ambient temperature range
da -30°C a 50°C.
ZVEI code
LED
Power Supply
Electronic Control gear included
Mounting options
Integral
Installation
Description
For wall-mounting using the special stainless steel plate. Secure using screw anchors for concrete, cement and solid brick. Product can be installed with the light beams in any direction (horizontal, vertical, slanting, etc.).;
Mounting
Wall surface, Ceiling surface
Wiring
Equipped with electronic ballast Vin=100-240V ac 50/60Hz. Available for electrical connection: Sealed connector kit IP68 (9581), direct connector IP68 (BZK6), junction box with quick-coupling terminals (BZK7)
Required accessories
To properly install and operate this product it’s necessary to have one of the required accessories
Go to required accessoriesNotes
Product complete with LED lamp.