074D
Colour
Required accessories
It is necessary to order one of the required accessories to properly install and operate the product:
Optional accessories
Technical Data
last update: 14/11/2025Description
Linear product for direct lighting, designed for the use of RGBW LED light sources (W=4000K). The product is installed either via a housing (to be purchased separately) for application to the ground, wall and ceiling. In the case of installation on walls or ceilings with panels, the housing is not necessary. Extruded aluminium body, with die-cast aluminium end caps complete with silicone gaskets and subjected to a multi-step pre-treatment process, in which the main phases are degreasing, fluorozirconation (surface protective layer) and sealing (nano-structured silane layer). The subsequent painting phase is carried out with primer and liquid acrylic paint, baked at 150°, which provides high resistance to atmospheric agents and UV rays. Optical compartment closed at the top by an 8mm thick transparent glass screen fixed with silicone. Complete with multi-LED power circuit in RGBW colour (W=4000K). Both the control board (available in both DMX-RDM and DALI versions) and the power supply unit must be purchased separately. Supplied with IP68 threaded ring connector. Equipped with No Dot optical system. All external screws used are made of A2 stainless steel.
Dimensions
General (mm)
1243x39x69
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Weight (kg)
1.9
Material
Aluminium
Product certification
-
CE -
UK Conformity Assessed
Photometric data
Details
lm system
437.5
W system
21.3
lm source
1250
W source
11
Luminous efficiency - lm/W (system value)
20.54
lm in emergency mode
-
Total light flux at or above an angle of 90° (Lm)
437.5
Light output ratio (LOR)
35
Optic and beam angle
General Light No-Dot
Adjustability
fixed
Colour temperature
RGBW - 4000K K
Electrical data
Operating ambient temperature range
da -30°C a 35°C.
ZVEI code
LED
Power Supply
Electronic Power supply not included
Mounting options
Remote
Control
PWM
LED Current
0.01
Installation
Description
The housing is required for installation (to be purchased separately), which allows recessed installation in the ground, recessed in the wall and recessed in the ceiling. In the case of installation on walls or ceilings with panels, the housing is not necessary. When installing on the floor, it is necessary to create a drainage channel or insert gravel for drainage under the housing before installation to guarantee the expected IP protection rating. For ceiling installation with plasterboard panels (thickness 1÷30mm), provide the preparation openings as shown in the instruction sheet and use the steel cable kit accessory with reinforcing plates.;
Mounting
Wall recessed, Floor recessed, Ceiling recessed, Ground recessed
Required accessories
To properly install and operate this product it’s necessary to have one of the required accessories
Go to required accessoriesNotes
Life Time only White LEDs on: 100,000h - L85 - B10 (Ta 25°C) Life Time only White LEDs on: 100,000h - L85 - B10 (Ta 40°C) Life Time only RGB on: 31,000h - L70 - B50 (Ta 25°C) Life Time only n.1 Coloured LED on: 45,000h - L70 - B50 (Ta 25°C).