806C
Colour
Required accessories
It is necessary to order one of the required accessories to properly install and operate the product:
Optional accessories
Technical Data
last update: 14/11/2025Description
Direct light linear luminaire, designed to use monochrome LED lamps. For ground and wall installations,, the product requires an outer casing (to be purchased separately). The outer casing is not required for installations in panelled walls and ceilings. The body is made of extruded aluminium and includes die-cast aluminium end caps with 50/60 Shore A silicone seals. It is subjected to a multi-step, pre-treatment process, in which the main phases are degreasing, fluorozirconation (a protective surface film) and sealing (with a nano-structured silane layer). The following painting stage consists of a primer and a liquid acrylic paint, cured at 150°C, with a high level of weather and UV ray resistance. The top of the optical assembly is closed by a 10mm thick transparent glass screen, fixed with silicone. Complete with Neutral White multi-LED circuit. Both the control card (available in a DMX-RDM and DALI version) and the power supply must be purchased separately. Supplied with a connector with an IP68 threaded locknut. Fitted with an Opti Beam Lens optical system with an Elliptical optic. All external screws used are made of A2 stainless steel.
Dimensions
General (mm)
947x39x69
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Weight (kg)
1.4
Material
Aluminium
Product certification
-
BIS -
CE -
UK Conformity Assessed
Photometric data
Details
lm system
979
W system
11.4
lm source
1780
W source
9
Luminous efficiency - lm/W (system value)
85.88
lm in emergency mode
-
Total light flux at or above an angle of 90° (Lm)
979
Light output ratio (LOR)
55
Optic and beam angle
E - Elliptical
Adjustability
fixed
Light colour quality
CRI (minimum) 80 - Rf (Colour Fidelity Index) 86 - Rg (Gamut Index) 95
Colour temperature
4000 K
MacAdam Step
3
Lifetime LED 1
100,000h - L85 - B10 (Ta 25°C)
Lifetime LED 2
100,000h - L85 - B10 (Ta 40°C)
Charts and polar curves
Electrical data
Operating ambient temperature range
da -30°C a 50°C.
ZVEI code
LED
Power Supply
Electronic Power supply not included
Mounting options
Remote
Control
PWM
LED Current
40
Installation
Description
The outer casing (to be purchased separately) is required for recessed floor, wall and ceiling installations. The outer casing is not required for installations in panelled walls and ceilings. For floor installations a drainage channel must be constructed or gravel inserted for drainage under the outer casing before installation, to guarantee the required IP protection rating. For ceiling installations with plasterboard panels (1-29 mm thick), make the preparation openings as indicated in the instructions sheet and use the steel cables with reinforcement plates in the accessory kit.;
Mounting
Wall recessed, Floor recessed, Ceiling recessed, Ground recessed
Required accessories
To properly install and operate this product it’s necessary to have one of the required accessories
Go to required accessories