BJ58
Colour
Optional accessories
Technical Data
last update: 21/10/2025Description
Direct light luminaire, designed to use RGB indicator LED lamps, with diffusing optic. Ceiling-/wall-mounted. Consists of a body and supports for installation, to be ordered separately. Extruded polycarbonate cylindrical body with semi-transparent (etched) finish and anti-UV treatment; die-cast Zamak cover plates and cable gland supports with opaque nickel galvanic treatment, complete with silicone seals. RGB version with electronic circuit 24V dc and multichip RGB indicator LEDs. Internal driver dimmable with PWM control can be controlled using Dali (code 9639) external control interface + electronic ballast to be ordered separately. Set up for pass-through wiring using a black plastic double PG11 cable gland and double multi-core cable L=500mm. Various wiring accessories are available: IP68 linear connectors for pass-through wiring, DIN bar or surface-mounted 24V dc external power supplies, dimming and control interfaces. All screws used are made of A2 stainless steel. The luminaire technical characteristics conform to EN60598-1 standards and particular requirements.
Dimensions
General (mm)
815x25x40
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Weight (kg)
0.92
Material
Polycarbonate
Product certification
-
ENEC-03
Photometric data
Details
lm system
206.78
W system
9.5
lm source
220
W source
6
Luminous efficiency - lm/W (system value)
21.77
lm in emergency mode
-
Total light flux at or above an angle of 90° (Lm)
7
Light output ratio (LOR)
94
Optic and beam angle
VWF - Very Wide Flood 114°
Adjustability
fixed
Colour temperature
RGB K
Lifetime LED 1
60,000h - L80 - B20 (Ta 25°C)
Charts and polar curves
Electrical data
Operating ambient temperature range
da -20°C a +35°C.
Voltage
24 DC
ZVEI code
LED
Power Supply
Electronic Control gear not included
Mounting options
Remote
Control
PWM
LED Current
13
Installation
Description
Product fixed using AISI304 stainless steel arms, L=60 and 120mm, complete with safety screw, to be ordered separately.;
Mounting
Wall arm, Wall surface, Ceiling surface
Wiring
Luminaire equipped with 24V dc electronic circuit and electronic ballast to be ordered separately. Set up for pass-through wiring using a black plastic double PG11 cable gland and double multi-core cable L=500mm. Available for electrical connections: 5-pin IP68 linear connector, suitable for cables with diameter D=8-17mm complete with terminal block for cables with max. section 2.5mm² and cover plate for connectors.
Notes
Product complete with LED lamp. In the last connector in the line, use the cover plate code BZQ7, eliminating the 120 Ohm resistor.