X933
Colour
Optional accessories
Technical Data
last update: 14/01/2026Description
DALI constant current dimmable electronic power supply for pole-mounted Palco InOut with minimal flange.
Power supply voltage Vin=220÷240 Vac 50÷60 Hz.
Power supply fitted with 3 outlet cables. High level of mains overvoltage, short circuit, polarity inversion and overtemperature protection.
The power supply current is regulated to allow the Palco InOut luminaires to operate in environments with a high temperature - Ta 40°C (life), Ta max 50°C.
The power supply current is regulated to allow the Palco InOut luminaires to operate in environments with a high temperature - Ta 40°C (life), Ta max 50°C.
Dimensions
General (mm)
167x61x39
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Weight (kg)
6
Product certification
-
EAC -
CCC Pending -
ENEC pending
Electrical data
Maximum number of luminaires of this type per minature circuit breaker
B10A: 8 power supply units
B16A: 14 power supply units
C10A: 14 power supply units
C16A: 23 power supply units
B10A: 8 power supply units
B16A: 14 power supply units
C10A: 14 power supply units
C16A: 23 power supply units
Overvoltage protection
10kV Common mode & 6kV Differential mode
Inrush current
86 A / 112 µs
Minimum dimming
10
Power Supply
Electronic Driver included
Mounting options
Integral
Dimmable option
Dimmable
Control
DALI-2
Frequency
50/60 Hz
Installation
Description
Fitted with flaps and slots for installation.
The power supply unit can only be installed inside poles designed specifically for Palco InOut luminaires with minimal flange and using the X743 code accessory, to be ordered separately.
;
The power supply unit can only be installed inside poles designed specifically for Palco InOut luminaires with minimal flange and using the X743 code accessory, to be ordered separately.
;
Wiring
The power supply unit is fitted with 3 outlet cables; input / DALI / luminaire output.
Cable lengths: input L= 260 mm, DALI L= 180 mm, output to luminaire L= 260 mm.
For the connections use the IP connectors recommended in the accessory section of the luminaire instruction sheet.
Cable lengths: input L= 260 mm, DALI L= 180 mm, output to luminaire L= 260 mm.
For the connections use the IP connectors recommended in the accessory section of the luminaire instruction sheet.
Notes
For information regarding the number of products that can be connected refer to the tables in the luminaire instruction sheet.
1 address, 1 DALI load (2 mA) Supports information 251, 252, 253.
The power supply unit can be programmed using the programming accessory code MY92 (not included). For example, a midnight-based profile can be set (not enabled by default).
1 address, 1 DALI load (2 mA) Supports information 251, 252, 253.
The power supply unit can be programmed using the programming accessory code MY92 (not included). For example, a midnight-based profile can be set (not enabled by default).
Compatible products
This accessory can be used with the following products