.jpg)
4188
Colour
Technical Data
last update: 02/08/2026Description
Floodlight fitted into the floor with body and screws made of A.I.S.I. 304-18-8 polished stainless steel; die cast aluminium ring painted in black; EPDM gaskets against dust and water. Ajustable optics made of anodized aluminium. Anchoring box composed of a die cast aluminium ring and a PVC tubolar element. Hardened protective transparent glass resistant up to 5000 Kg. PG13,5 cable clamp. Wiring plate made of galvanized steel.
Dimensions
Diameter (mm)
ø220
Shape
Round
Recessed hole dimensions (mm)
ø180
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Stainless steel
Photometric data
Details
lm system
W system
lm source
W source
100
Luminous efficiency - lm/W (system value)
lm in emergency mode
-
Maximum intensity (cd)
9000
Total light flux at or above an angle of 90° (Lm)
0
Light output ratio (LOR)
94
Optic and beam angle
Colour temperature
Lifetime LED 1
Lifetime LED 2
Charts and polar curves
Electrical data
Operating ambient temperature range
from -20°C to +35°C.
Installation
Description
Fitted into the floor. The anchoring box is embedded in the ground (check that is flush with the paving) and cement is cast all around so as to provide a gravel layer for a good drainage and a valid seal. Anchoring box diameter 225 mm, height 295 mm.;
Mounting
Ground recessed
Wiring
Wiring for PAR30 100W lamps contained in the body of the fitting. Possible wiring with two P13 water-tight cable clamps.
Notes
The luminaire should be installed with the outer casing (code 5936), which can be ordered separately.