.jpg)
5182
Colour
Technical Data
last update: 25/08/2026Description
Wall/Ceiling-mounted multilamp fitting. Extruded-aluminium connection rod complete with joint for adjusting the whole structure and screw mechanical locking device. Steel anchoring plate and die-cast aluminium base. The die-cast aluminium optical assemblies have joints that make it possible to tilt each individual light source by +45° on the horizontal and vertical axes. The electronic transformers are integrated into the structural frame and are protected by a technopolymer cover
Dimensions
General (mm)
385x320
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Aluminium
Photometric data
Details
lm system
W system
lm source
W source
Luminous efficiency - lm/W (system value)
lm in emergency mode
-
Total light flux at or above an angle of 90° (Lm)
0
Light output ratio (LOR)
100
Optic and beam angle
Colour temperature
Lifetime LED 1
Lifetime LED 2
Electrical data
Operating ambient temperature range
Voltage
220-240 VAC
Power Supply
Electronic Transformer included
Mounting options
Integral
Installation
Description
Wall or ceiling installation in either longitudinal or transversal position. The anchoring plate is fixed by screws and screw anchors.;
Mounting
Wall surface, Ceiling surface
Wiring
Mains connection by standard terminal board on anchoring plate. The custom-built dimmable electronic transformers (IGBT technology) have the following safety systems: thermal protection / soft start / output short-circuit protection / vacuum protection (with no load) / overload protection / output voltage stabilised according to power variation.
Notes
For the photometric data of the fitting refer to the photometric data of the light sources used. Complete with one adjustable fixing rod.