.jpg)
6657
Colour
Technical Data
last update: 25/08/2026Description
Aluminium track. Conductors housed inside the interior of the track. Conductors shielded by rigid extruded isolating material that has a very high dielectric resistance. The 3-phase wires with a common ground provide 3 separate circuits that allow the use of 3 distinct switches. Available with 80W T16 fluorescent module for up light emission and DALI control gear.
Dimensions
General (mm)
3000x43x71
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Aluminium
Product certification
-
ENEC-03
Photometric data
Details
lm system
W system
lm source
W source
Luminous efficiency - lm/W (system value)
Optic and beam angle
Colour temperature
Lifetime LED 1
Lifetime LED 2
Electrical data
Operating ambient temperature range
Voltage
220-240 VAC
Power Supply
Control gear included
Mounting options
Integral
Installation
Description
For ceilings. Tracks have fastening supports or can be installed via rods or cables with different lengths which can be fastened to the support joints. The tracks can also be installed at a height of 2.50 m or lower from the floor, in order to place them closer to work spaces.;
Mounting
Ceiling pendant
Wiring
The electric conductors are such that will allow for the following types of installation: 220/250V: connection to a single phase electricity network of 220/250V allows for a total load of 16 A that corresponds to 3500/4000 V/A, which can be divided onto three circuits. 220/380V: connection to a 3-phase electricity network of 220/380V allows for a total load of 16 A that corresponds to 10500 V/A, and which can be divided into three circuits (3x3500 V/A).
Notes
Tracks come equipped with a series of accessories that supply power to the conductors and allow various tracks and to be joined. This is possible with end caps with power supplies, direct joints, T-joints, cross joints, and L-joints. The joints are all equipped with 5 conductor wires. The lateral position of the grounding wire makes the track structure asymmetrical. Therefore the connecting joints should be chosen by keeping this in mind. Occupies 1 DALI address.