.jpg)
8370
Colour
Technical Data
last update: 25/08/2026Description
Downlight designed for use with halogen lamp 75W 12V QT12 / 100W 24V QT12 Gy6.35 and equipped with low-luminance professional optics. The light source may be adjusted inside the false ceiling. A perimetric diecast aluminium ring supports an internal revolving ring through a thermoplastic sliding device to which the galvanized sheet steel adjustable brackets are connected to support the lampholder, the upper reflector and the diecast aluminium dissipator. The superpure aluminium lower reflector is connected to the support ring by two counter springs. The light source can be adjusted by 45° on the vertical plane and 358° on the horizontal plane, and the angling system may be fixed. A borosilicate protection glass permits using high pressure lamps too.
Dimensions
Diameter (mm)
ø168
Shape
Round
Recessed hole dimensions (mm)
ø153
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Die-cast aluminium
Photometric data
Details
lm system
W system
lm source
W source
100
Luminous efficiency - lm/W (system value)
lm in emergency mode
-
Maximum intensity (cd)
8414
Total light flux at or above an angle of 90° (Lm)
0
Light output ratio (LOR)
59
Optic and beam angle
Adjustability
rotation and tilt updown
Colour temperature
Lifetime LED 1
Lifetime LED 2
Electrical data
Operating ambient temperature range
Voltage
12 VDC
Power Supply
Electronic Transformer included
Mounting options
Remote
Installation
Description
Recessed installation into false ceilings 1 to 30 mm thick (hole diameter: 153 mm). The fastening brackets are made of steel and can be adjusted for height.;
Mounting
Ceiling recessed
Wiring
Connection to the power supply by fireproof silicone-insulated cable which comes standard with the fitting.
Notes
Bi-pin lamps with a longitudinal filament should be used for the best performance of the optics.