.jpg)
MB24
Colour
Technical Data
last update: 25/08/2026Description
A spotlight with minimalist lines set up for surface-mounted installation and particularly suitable for placing on cornices, architraves and shelves. The central joint system allows easy tilting in all directions. Version for HIT-TC 70W metal halide lamp. Extruded aluminium components body with extruded aluminium closing end caps. Fixing plate with galvanised shaped steel plate surface. Die-cast aluminium lamp holder assembly, joints and arms. High performance super-pure aluminium reflector - spot optic. Tilting: -35°/+90° relative to the horizontal plane; 359° relative to the vertical plane. Anti-glare screen available with separate code MWP2, allowing insertion of the glass accessory components envisaged.
Dimensions
Diameter (mm)
ø118
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Aluminium
Product certification
-
ENEC-03
Photometric data
Details
lm system
W system
lm source
W source
70
Luminous efficiency - lm/W (system value)
lm in emergency mode
-
Maximum intensity (cd)
48113
Total light flux at or above an angle of 90° (Lm)
0
Light output ratio (LOR)
82
Optic and beam angle
S - Spot 14°
Adjustability
directional
Colour temperature
Lifetime LED 1
Lifetime LED 2
Electrical data
Operating ambient temperature range
Voltage
220-240 VAC
ZVEI code
HIT-TC-CE
Power Supply
Electronic Control gear included
Mounting options
Integral
Installation
Description
In addition to the position surface mounted on the horizontal plane, other installations are possible on a vertical wall and with the turned through 180°, allowing good aiming in any circumstances. Anchor plate fixed using screws and screw anchors with subsequent mechanical fixing of the components body to the plate.;
Mounting
Wall bracket
Wiring
The product comes complete with an electronic ballast in the components body; power supply wiring connected on the anchor plate using a quick coupling terminal block; set up for pass-through wiring with a protective rubber gasket.
Notes
The anti-glare screen, code MWP2, is needed to allow the use of the glass accessory components: 9643 (refractor for elliptical distribution) - 8782 (coloured filters) - 9435 (UV filter)