.jpg)
X785
Colour
Technical Data
last update: 06/08/2026Description
Kit for Citygrid Gateway installation on a local electrical cabinet, consisting of a rubber membrane and a 1.5 m long cable with an IP connector plus a safety locknut.
The Gateway (not included) is fixed to the electrical cabinet using 2 self-tapping screws (not included).
The cable supplied with this Kit is a 4 conductor cable, that both powers the Gateway and can be used for an eventual internal relay commanded by the Dashboard.
Dimensions
General (mm)
15x57x146
Technical performance
Complies with EN60598-1 and pertinent regulations
Physical properties
Material
Thermoplastic
Photometric data
Details
lm system
W system
lm source
W source
Luminous efficiency - lm/W (system value)
Total light flux at or above an angle of 90° (Lm)
Optic and beam angle
Colour temperature
Lifetime LED 1
Lifetime LED 2
Electrical data
Operating ambient temperature range (C°)
Installation
Description
A hole must be drilled in the cabinet panel or internal fixing bracket to allow the cable and connector (that exit the rear of the Gateway) to pass through them.
Wiring
The Kit’s cable and connector must be connected to the 220-240 Vac electrical network via two conductors (L-N).
A third conductor (mains power out) can be connected to a 230 Vac device with a maximum absorption of 1.0 A. We recommend connecting auxiliary command components to this output like relays/conductors.
Notes
Consult the cabinet manufacturer for more information about drilling and an eventual successive protection.
Additional Information
Description
Available, at the moment, for the European market only.